Download New Updated (Spring 2015) Cisco 350-001 Actual Tests 151-160

By | April 22, 2015

Ensurepass

 

QUESTION 151

Refer to the exhibit. Which output will the EEM applet in the exhibit produce?

 

clip_image001

 

A.       The output of show version will be executed every 5 hours.

B.       The output of show log will be executed every 5 hours.

C.       The output of show log will be executed every Friday.

D.      The output of show log will be executed every 5 minutes.

 

Correct Answer: D

 

 

QUESTION 152

Refer to the exhibit. Why is the interface in the up/down state?

 

clip_image003

 

A.       There is no physical layer connection.

B.       A span session has been configured with g5/2 as the destination.

C.       There were too many input drops on the interface.

D.      A span session has been configured with g5/2 as the source

 

Correct Answer: B

 

 

QUESTION 153

Refer to the exhibit. You are investigating a performance problem between two hosts. You have enabled NetFlow. What is most likely the cause of this issue?

 

clip_image005

 

A.  A firewall is stripping the TCP MSS option.

B.  A firewall is stripping the IP MSS option.

C.  An IPS is stripping the TCP MSS option.

D.  There is a VPN link causing low MTU.

E.  You must configure the MTU on the links on the router.

Correct Answer: A

 

 

QUESTION 154

Multicast is being deployed in the network, and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast, the network monitoring tools show periodic spikes in link utilization throughout the network, even in areas where the video application is not being used. What could be a possible cause?

 

A.       PIM sparse mode is being used.

B.       PIM dense mode is being used.

C.       The BGP multicast address family has not been configured.

D.      IGMP version 3 is being used.

E.       IP PIM neighbor filters have not been applied.

 

Correct Answer: B

 

 

QUESTION 155

Which two attributes need to match for two switches to become members of the same MST region? (Choose two.)

 

A.       the table of 4096 elements that map the respective VLAN to STP instance number

B.       VTP version

C.       configuration revision number

D.      native VLAN ID

 

Correct Answer: AC

 

 

QUESTION 156

An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port, 100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers, resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application? (Choose two.)

 

A.       change the EtherChannel default hashing algorithm from XOR to use source port Layer 4 port load balancing to better load balance the traffic

B.       change the EtherChannel default hashing algorithm from XOR to use destination Layer 4 port load balancing to better load balance the traffic

C.       have the application recoded to use multiple connections instead of a single connection so EtherChannel can better load
balance the traffic

D.       upgrade the CPU and memory of the compute devices so they can better process traffic

E.        upgrade the EtherChannel bundle to a single gigabit link because EtherChannel is not well suited for single-connection traffic

 

Correct Answer: CE

 

 

QUESTION 157

Which two are natively included by the IEEE 802.1w standard? (Choose two.)

 

A.       instances can control a selection of VLANs

B.       load balancing

C.       fast transition to forwarding state

D.      backbone, uplink, and portfast (or equivalent)

E.       root, loop, and BPDU guard (or equivalent)

 

Correct Answer: CD

 

 

QUESTION 158

Which three statements are true about policing? (Choose three.)

 

A.       Out-of-profile packets are queued.

B.       It causes TCP retransmits.

C.       Marking and remarking are not supported.

D.      It does not respond to BECN and foresight messages.

E.       It uses a single- and two-bucket mechanism for metering.

 

Correct Answer: BDE

 

 

QUESTION 159

Which command can be used to filter a RIPv6 route from getting installed in the routing table?

 

A.        ipv6 router rip ccie

distribute-list..

 

B.        ipv6 router rip ccie

offset-list..

 

C.        interface e0/0

ipv6 rip ccie distribute-list..

 

D.        interface e0/0

ipv6 rip ccie advertise..

 

Correct Answer: A

 

 

QUESTION 160

Which three are needed to run VRF lite for IPv6 on a router? (Choose three.)

 

A.       VRF definition for IPv6

B.       MP BGP for IPv6

C.       LDP

D.      VRF-enabled routing protocol

E.       VRF-enabled interface

 

Correct Answer: ADE

 

Free VCE & PDF File for Cisco 350-001 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …