Download New Updated (Spring 2015) Cisco 350-030 Actual Tests 101-110

By | April 26, 2015

Ensurepass

 

QUESTION 101

According to RFC 3551, where default mappings between RTP payload type numbers and encodings are defined, which RTP payload type corresponds to encoded packets that are triggered by silence on a call with voice activity detection?

 

A.      0

B.      13

C.      15

D.      18

 

Correct Answer: B

 

 

QUESTION 102

Which version of MGCP is used on a Cisco IOS MGCP gateway that is registered to Cisco Unified Communications Manager?

 

A.      0.0

B.      0.1

C.      1.0

D.      1.1

E.       It varies between Cisco Unified Communications Manager versions.

 

Correct Answer: B

 

 

QUESTION 103

On a Cisco IOS MGCP gateway, which DTMF relay method uses MGCP NTFY messages to send digits to Cisco Unified Communications Manager?

 

A.      Cisco

B.      NSE

C.      NTE-CA

D.      NTE-GW

E.       out-of-band

 

Correct Answer: E

 

 

QUESTION 104

Which SCCP message is used to instruct to an SCCP IP phone the remote IP address and port number to send RTP packets?

 

A.      Station IP Port message

B.      Station Open Receive Channel message

C.      Station Start Media Transmission message

D.      Station Call Information message

E.       Station Open Logical Channel message

 

Correct Answer: C

 

 

QUESTION 105

An IP phone user just answered an incoming call by lifting the handset. Assuming that the IP phone uses SCCP, which SCCP
message will Cisco Unified Communications Manager transmit to this called IP phone immediately after receiving notification about the off-hook event?

 

A.      Station Media Port List message

B.      Station Set Ringer message

C.      Station Stop Tone message

D.      Station Start Media Transmission message

E.       Station Open Receive Channel message

Correct Answer: B

 

 

QUESTION 106

Which SCCP message is used by an IP phone to inform Cisco Unified Communications Manager about the IP address and port number to be used for an incoming RTP stream?

 

A.      Station Capability Response message

B.      Station IP Port message

C.      Station Open Receive Channel ACK message

D.      Station Media Reception ACK message

E.       Station Start Media Transmission message

 

Correct Answer: C

 

 

QUESTION 107

When an IP phone that is using SCCP places an active call on hold, which SCCP message will be transmitted from the phone to Cisco Unified Communications Manager?

 

A.      Station On Hold message

B.      Station Keypad Button message

C.      Station Close Receive Channel message

D.      Station Stop Media Transmission message

E.       Station Softkey Event message

 

Correct Answer: E

 

 

QUESTION 108

What is the proper Cisco IOS CLI command to configure an analog FXS port to be controlled by Cisco Unified Communications Manager using SCCP?

 

A.      dial-peer voice 1 pots

port 1/0

service skinny

 

B.      dial-peer voice 1 pots

port 1/0

service sccp

 

C.      dial-peer voice 1 pots

port 1/0

service stcapp

 

D.      dial-peer voice 1 pots

port 1/0

service sccpapp

 

E.       dial-peer voice 1 pots

port 1/0

application sccp

 

Correct Answer: C

 

 

QUESTION 109

Refer to the exhibit. Listed in the exhibit are five attributes that a Cisco IOS router uses to select an inbound dial peer. Which attribute order, from highest to lowest priority, is used by a Cisco IOS router for inbound dial-peer matching?

 

clip_image002

 

A.      II, I, III, V, IV

B.      III, I, II, V, IV

C.      III, II, I, V, IV

D.      II, III, I, V, IV

E.       V, III, II, I, IV

F.       V, II, III, I, IV

 

Correct Answer: C

 

 

QUESTION 110

Which two attributes are not used by a Cisco IOS router in the inbound dial-peer selection process? (Choose two.)

 

A.      default dial-peer 0

B.      called number with the destination-pattern command of each dial peer

C.      calling number with the destination-pattern command of each dial peer

D.      calling number with the answer-address command of each dial peer

E.       called number w
ith the incoming called-number command of each dial peer

F.       called number with the answer-address command of each dial peer

G.      voice port that is associated with an incoming call

 

Correct Answer: BF

Free VCE & PDF File for Cisco 350-030 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …