Download New Updated (Spring 2015) Cisco 350-030 Actual Tests 121-130

By | April 26, 2015

Ensurepass

 

QUESTION 121

Refer to the exhibit. Which dial peer will the Cisco IOS voice gateway match if an incoming call with a calling number of 100 and called number of 101 arrives at this T1 PRI port?

clip_image002

 

A.      dial-peer voice 2

B.      dial-peer voice 3

C.      dial-peer voice 5

D.      dial-peer voice 8

E.       dial-peer voice 0

 

Correct Answer: B

 

 

QUESTION 122

Refer to the exhibit. Which dial peer will the Cisco IOS voice gateway match if an incoming call with a calling number of 100 and called number of 101 arrives at this T1 PRI port?

 

clip_image004

A.      dial-peer voice 2

B.      dial-peer voice 3

C.      dial-peer voice 5

D.      dial-peer voice 8

E.       dial-peer voice 0

 

Correct Answer: D

 

 

QUESTION 123

Refer to the exhibit. Which two statements about this debug message that was captured from a Cisco IOS H.323 gateway are correct? (Choose two.)

 

clip_image005

 

A.      The calling-party number is 2000.

B.      If this gateway is able to accept the call, it should respond with an H.225 call proceeding message.

C.      If this gateway is able to accept the call, it should respond with an H.225 setup ACK message.

D.      If this gateway is able to accept the call, it should respond with an H.225 connect ACK message.

E.       The called-party number is 2000.

F.       Neither gateway is allowed to begin RTP transmission until the H.225 connect message is sent.

 

Correct Answer: AC

 

 

QUESTION 124

Which Cisco IOS command and configuration mode can be used to force a Cisco IOS voice gateway to use TCP as the transport protocol for SIP?

 

A.      router(config)#sip transport tcp

B.      router(conf-voi-serv)#no sip transport udp

C.      router(conf-serv-sip)#no transport udp

D.      router(conf-serv-sip)#transport tcp

E.       router(config-sip-ua)#no transport udp

 

Correct Answer: E

 

 

QUESTION 125

Refer to the exhibit. The exhibit shows how MOH Server A and MOH Server B are associated with Phone A and Phone B. If Phone A presses the Hold softkey during an active call with Phone B using the G.711 mu-law codec, which two statements are correct? (Choose two.)

 

clip_image007

 

A.      MOH Server A will be used to play MOH toward Phone B.

B.      MOH Server B will be used to play MOH toward Phone B.

C.      Phone B will continue using G.711 as the codec to receive MOH.< /font>

D.      Phone B will use G.729 as the codec to receive MOH by default.

E.       Phone B will renegotiate the codec with the selected MOH server based on the region settings of both parties.

 

Correct Answer: BE

 

 

QUESTION 126

When calls are placed by certain Cisco Unified Communications Manager supplementary services, the Local Route Group feature will be bypassed. Which of these does not belong to the supplementary services?

 

A.      Call Back

B.      Call Forward

C.      Message Waiting Indicator

D.      Mobility Follow Me

E.       Path Replacement

 

Correct Answer: B

 

 

QUESTION 127

Phone A, Phone B, and Phone C are configured to be in Device Pool A, Device Pool B, and Device Pool C, respectively. The Local Route Group feature was configured on Cisco Unified Communications Manager for each device pool. Phone B has set CFA to Phone C; Phone C has set CFNA to a PSTN number. When Phone A calls Phone B and if Phone C does not answer, which local route group will be used to route the call?

 

A.      The local route group that is configured for the Phone A device pool will be used.

B.      The local route group that is configured for the Phone B device pool will be used.

C.      The local route group that is configured for the Phone C device pool will be used.

D.      All local route groups will be bypassed.

E.       Cisco Unified Communications Manager will disallow the forwarded call because it might cause routing loops.

 

Correct Answer: A

 

 

 

 

 

 

 

 

QUESTION 128

Refer to the exhibit. The exhibit shows the T.30 message exchanges that resulted in a single page fax call failure. Which T.30 message sequence will result in a successful fax transmission?

 

clip_image008

 

A.      PPS, EOP, PPR, PPS, EOP, NSF, DCN

B.      MPS, EOP, PPR, PPS, EOP, MCF, DCN

C.      PPS, EOP, RTP, PPS, EOP, NSF, DCN

D.      PPS, EOP, PPR, PPS, EOP, MCF, DCN

E.       PPS, EOP, NSF, DCN

 

Correct Answer: D

 

< font face="Calibri"> 

 

 

QUESTION 129

Refer to the exhibit. The debug outputs that are shown in the exhibit were collected at the terminating Cisco IOS gateway for a fax call that failed. Which two of these could be the failure reasons? (Choose two.)

 

clip_image010

 

A.      The fax originated from a third-party fax gateway.

B.      The fax originated from a Cisco gateway that is configured with a protocol-based Cisco fax relay.

C.      The fax originated from a Cisco gateway that is configured with a protocol-based fax passthrough.

D.      The fax originated from a Cisco gateway that is configured with an NTE-based fax passthrough.

E.       The fax originated from a gateway that is configured with an NSE-based fax relay.

 

Correct Answer: AC

 

 

QUESTION 130

Which MGCP message is used to indicate fax switchover in a call agent-controlled T.38 fax relay?

 

A.      CRCX

B.      NSE

C.      NTE

D.      NTFY

E.       MDCX

 

Correct Answer: E

 

Free VCE & PDF File for Cisco 350-030 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …