Download New Updated (Spring 2015) Cisco 642-832 Actual Tests 11-20

By | April 28, 2015

Ensurepass

 

QUESTION 11

Refer to the shown below. What statement is correct regarding the output shown in the graphic?

 

% LINK-3-UPDOWN: Interface Serial0/0, change state to up

% LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up

 

A.       These two log messages will not have severity level. They are not errors but are just informational messages.

B.       The first log message is categorized as a warning message.

C.       These messages regarding interface status are normal output and will always be displayed when you exit config mode.

D.       The first log message is an error message with a severity level of 3.

E.        The second message would be shown if the logging console warning command had been issued.

 

Correct Answer: D

 

 

 

 

 

 

 

QUESTION 12

Refer to the configuration statements shown in the graphic above. Which statement reflects what the effect is of this configuration sequence?

 

clip_image002

 

A.      These commands will generate an error message because you cannot use an access list with any debug commands.

B.      These commands will have no effect at all. The debug ip packet command will work as normal and display info for all IP packets.

C.      These commands turn on debug ip packet only for packets between hosts 10.1.1.1 and 172.16.1.1.

D.      These commands will only work when you specify only one host rather than two.

 

Correct Answer: C

 

 

QUESTION 13

What is the result if you configure two devices with the ntp server command?

 

A.      Nothing will happen until one of the devices is configured with the prefer parameter.

B.      The NTP protocol will determine which server is most reliable and will synchronize to that server.

C.      The device with the highest priority will become the active server and the other device will become the backup server.

D.      The device with the lowest MAC address will become the active server and the other device will become the backup server.

 

Correct Answer: B

 

 

QUESTION 14

A technician is troubleshooting connectivity problems between two routers that are directly connected through a serial line. The technician notices that the serial line is up, but cannot see any neighbors displayed in the output of the show cdp neighbors command. In which OSI layer is the problem most likely occurring?

 

A.      physical

B.      data link

C.      network

D.      transport

E.       application

 

Correct Answer: B

 

 

QUESTION 15

What are two approaches to maintaining a network?(Choose two)

 

A.      PPDIOO

B.      structured

C.      bottoms up

D.      interrupt-driven

 

Correct Answer: BD

 

 

QUESTION 16

FCAPS is a network maintenance model defined by ISO. FCAPS stands for:

 

clip_image004

 

Correct Answer:

clip_image006

 

 

 

 

QUESTION 17

There are many Network Maintenance models. Match the model names on the left to the options on the right:

 

clip_image008

 

Correct Answer:

clip_image010

 

 

QUESTION 18

Match the items on the left to their purpose on the right:

 

clip_image012

 

Correct Answer:

clip_image014

 

 

QUESTION 19

Ticket 1: Switch Port Trunk

Scenario: The implementation group has been using the test bed to do a ‘proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing schemes, DHCP services, layer 2 connectivity, FHRP services, and, device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

clip_image016

clip_image018

 

Trouble Ticket Statement

 

Client 1 and Client 2 are getting a 169.x.x.x IP address and are not able to ping DSW1 or the FTP Server. They are able to ping each other.

 

Configuration on ASW1

 

Interface PortChannel13 switchport mode trunk

switchport trunk allowed vlan 1-9

!

Interface PortChannel23 switchport mode trunk

switchport trunk allowed vlan 1-9

!

Interface FastEthernet1/0/1 switchport mode access switchport access vlan 10

!

Interface FastEthernet1/0/2 switchport mode access switchport access vlan 10

!

 

On which device is the fault condition located?

 

A.      ASW1

B.      DSW1

C.      Client 1

D.      FTP Server

E.       ASW2

F.       DSW2

 

Correct Answer: A

 

 

QUESTION 20

Ticket 1: Switch Port Trunk

Scenario: The implementation group has been using the test bed to do a ‘proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing schemes, DHCP services, la
yer 2 connectivity, FHRP services, and, device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

clip_image016[1]

clip_image018[1]

 

Trouble Ticket Statement

 

Configuration on ASW1

 

clip_image020

 

 

The Fault Condition is related to which technology?

A.       NTP

B.       Switch to Switch Connectivity

C.       Access Vlans

D.       Port Security

E.        VLAN ACL / Port ACL

F.        Switch Virtual Interface

 

Correct Answer: B

 

Free VCE & PDF File for Cisco 642-832 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …