Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 Aug VMware Official New Released VCP-310
100% Free Download! 100% Pass Guaranteed!
CCIE Collaboration (v1.1)
Question No: 301 – (Topic 1)
Which definition is included in a Cisco UC on UCS TRC?
-
Required RAID configuration When TRC uses direct attached storage
-
Configuration of virtual-to-physical network interface mapping
-
Step-by-step procedures for hardware BIOS, firmware, drivers, and RAID setup
-
Server model and local components (CPU, RAM, adapters, local storage) by name only. Part numbers are not included because they change over time
-
Configuration settings and patch recommendations for VMware software
Answer: A
Question No: 302 – (Topic 1)
Tom Lee is an active user in a Cisco Unified CM deployment with fully functional LDAP synchronization and authentication to an Active Directory. Daily resynchronization is set at 11:00 pm. At 8:00 am on March 1st 2014, this user was deleted from the AD.
What will Tom Lee experience when he attempts to log in Extension Mobility at an IP phone and then access his Unified CM User Options page on his PC, at 9:00 am on March 1st 2014?
-
Extension Mobility will not work, but the User Options page will work.
-
Extension Mobility and the User Options page will not work.
-
Extension Mobility will work, but the User Options page will not work.
-
Extension Mobility and the User Options page will work.
-
The information provided is insufficient to answer this question.
Answer: C
Question No: 303 – (Topic 1)
Which three issues prevent a customer from seeing the presence status of a new contact in their Jabber
contact list? (Choose three.)
-
Incoming calling search space on SIP trunk to IMamp;P
-
IMamp;P incoming ACL blocking inbound status
-
Subscribe calling search space on SIP trunk to IMamp;P
-
PC cannot resolve the FQDN of IMamp;P
-
Owner user ID is not set on device
-
Primary DN is not set in end user configuration for that user
-
Subscriber calling search space is not defined on user#39;s phone
Answer: B,C,D Explanation:
No Presence Information After Login Problem
You receive no Presence information after login. Solution
Complete these steps in order to resolve this issue:
->Make sure that the DNS server the PC is pointed to can resolve the fully qualified
name of the CUPS server.
The host entry will not suffice, you must resolve via DNS.
->Check the SUBSCRIBE CSS on the SIP trunk to CUP.
This CSS must include the partitions of the devices you are trying to receive status on.
->The CUP SIP proxy incoming access control list (ACL) is not allowing incoming SIP presence messages to reach the presence engine. As a test, set the incoming ACL to ALL and reset the SIP proxy and presence engine. Log in again to the CUPC and try to reconfigure the incoming ACL properly.
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified- presence/97443-cups-cupc-ts.html
Question No: 304 – (Topic 1)
A queued call has-reached the maximum wait time configured for a Cisco Unified Communications Manager native call queue. Which statement about what happens to this queued call is true??
-
Calls are handled according to the Not Available Hunt Option settings on the Line Group Configuration page
-
Calls are handled according to the When Queue Is Full settings on the Hunt Pilot Configuration page.
-
Calls are handled according to the When Maximum Wait Time Is Met settings on the Hunt Pilot
Configuration page.
-
Calls are handled according to the Forward Hunt No Answer settings on the Hunt Pilot configuration page.
-
Calls are handled according to the When Maximum Wait Time Is Met settings in Cisco Unified Communications Manager Service Parameters.
Answer: C
Question No: 305 – (Topic 1)
Refer to the exhibit.
What happens to the USB e-token after the administrator fails to enter the correct password at the next attempt?
-
The token is locked for five days, after which the retry counter resets.
-
The token is locked until unlocked by Cisco TAC.
-
The token is locked until Cisco CTL Client is uninstalled and reinstalled on the client PC.
-
The token cannot be used on the same client PC again. It can be used with another Cisco CTL Client on a different PC.
-
The token is locked forever.
Answer: E
Question No: 306 – (Topic 1)
A voice engineer is trying to configure CUCM to satisfy the following customer codec requirements.
-
All IP phones should use audio codec at less than 10K bandwidth and maintain voice quality
-
The IP phone audio codec selected should be optimized for speech and music
-
The audio codec should be used in outbound SIP early offer signaling Which configuration best satisfy the requirement?
A)
B)
C)
D)
-
Exhibit A
-
Exhibit B
-
Exhibit C
-
Exhibit D
Answer: C
Question No: 307 – (Topic 1)
Which TFTP server address selection option has the highest precedence on Cisco SCCP IP phones using firmware release 8.0(4) or later?
-
a manually configured alternate TFTP option on the phone
-
the first Option 150 IP address received from the DHCP server
-
the first Option 66 dotted decimal IP address received from the DHCP server
-
the first IPv6 TFTP Server address received from the DHCP server
-
the value of next-server IP address in the boot-up process
Answer: A
Question No: 308 – (Topic 1)
Refer to the exhibit.
Which two commands, when configured on a PPP multilink interface allow a fragment size of 160 bytes? (Choose two).
-
bandwidth 128
-
ppp multilink fragment-delay 40
-
ppp multilink fragment-delay 15
-
bandwidth 384
-
ppp multilink fragment-delay 10
-
bandwidth 512
-
ppp multilink fragment-delay 20
-
bandwidth 768
Answer: A,E
Question No: 309 – (Topic 1)
Refer to the exhibit.
A collaboration engineer configured MVA for a company using an existing Cisco IOS voice gateway.
When testing inbound calls it is found that they are all failing.
Which two sets of configuration changes fix this problem? (Choose two)
-
Dial-peer voice 4100 pots Services ccm
Destination-pattern 4100$
-
Dial-peer voice 4101 voip Dtmf-relay h245-alphanumeric
Session target ipv4:172.16.100.50
-
Dial-peer voice 4101 voip Dtmf-relay h245-alphanumeric
Session target ipv4:172.16.100.50 Codec g711ulaw
-
Dial-peer voice 4100 pots service CCM
-
Dial-peer voice 4100 pots service CCM
Incoming called-number .T
-
Dial-peer voice 4101 VOIP Dtmf-relay h245-signal
Session target ipv4:172.16.100.50 Codec g711alaw
Answer: C,E Explanation:
Please note that, current scenario we are talking only inbound calls.Tricky question
http://www.cisco.com/c/en/us/support/docs/unified-communications/unified- communications-manager-callmanager/200457-Configure-the-Mobile-Voice-Access- Featur.html#anc6
Configuration Example
application
service mva http://10.106.103.149:8080/ccmivr/pages/IVRMainpage.vxml
dial-peer voice 5050 pots service mva
incoming called-number 5050
no digit-strip direct-inward-dial
!
dial-peer voice 3001 voip destination-pattern 5050
session target ipv4:10.106.103.149 dtmf-relay h245-alphanumeric codec g711ulaw
no vad
Question No: 310 – (Topic 1)
Which option is a mandatory LDAP attribute for a user to be synchronized to Cisco Unified Communications Manager?
-
uid
-
telephone Number
-
employee Number
-
sn
-
mail
Answer: D
100% Dumps4cert Free Download!
–VCP-310 PDF
100% Dumps4cert Pass Guaranteed!
–VCP-310 Dumps
Dumps4cert | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |