Ensurepass.com : Ensure you pass the IT Exams
2018 Jan Cisco Official New Released 300-080
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/300-080.html
Troubleshooting Cisco IP Telephony amp; Video v1.0
Question No: 31
Where in Cisco TMS would you see if a system is registered to a Cisco VCS or a Cisco Unified Communications Manager?
-
Systems gt; Registration
-
Navigation gt; Systems gt; Registrations
-
under Registration on the System Administration tab
-
System Overview
-
Settings gt; Provisioning
-
where you start the Cisco Unified Communications Manager RTMT under Systems and Reports
Answer: D
Question No: 32
Refer to Exhibit:
After reviewing the trace in the exhibit, what was the Directory number of the called party?
A. 2001
B. 5010
C. 1905
D. 2003
Answer: D
Question No: 33
Refer to the exhibit.
Assume a centralized Cisco Unified Communications Manager topology with the headquarters at RTP and remote located at the U.K. All route patterns are assigned a route list that contains a route group pointing to the local gateway. RTP route patterns use the RTP gateway, and U.K. route patterns use the U.K. gateway.
When a U.K. user logs into an RTP phone using the Cisco Extension Mobility feature and places an emergency call to 0000, which statement about the emergency call is true?
-
The call will match the U.K_Emergency route pattern partition and will egress at the RTP gateway.
-
The call will match the U.K_Emergency route pattern partition and will egress at the U.K. gateway.
-
The call will match the RTP_Emergency route pattern partition and will egress at the RTP gateway.
-
The call will match the RTP_Emergency route pattern partition and will egress at the
U.K. gateway.
-
The call will fail.
Answer: B
Question No: 34
After a Cisco Unified Communications Manager system is installed, users report problems when more than four users attempt to join a Meet-Me conference. Which parameter should you increase?
-
Maximum Ad Hoc Conference, Call Manager Service Parameter
-
Maximum Ad Hoc Conference, Enterprise Parameters Configuration
-
Maximum Meet-Me Conference, Call Manager Service Parameter
-
Maximum Meet-Me Conference, Enterprise Parameters Configuration
Answer: C
Question No: 35
An inbound call from the PSTN is not reaching the directory number that it is calling. When the PSTN phone calls the correct DID, only a dial tone is heard. Which command resolves this issue?
-
(config-dial-peer)#direct-inward-dial
-
(config-controller)# no provide-outside-dialtone
-
(config-if)#no dial-tone
-
(config-dial-peer)# no dial-tone
-
(config-if)#direct-inward-dial
-
(config) allow inbound dial-peer 1
Answer: A
Question No: 36 DRAG DROP
Drag the network-related video issue on the left to its root cause on the right.
Answer:
Question No: 37
Refer to the exhibit.
A CUCM user has been configured to use the Mobility feature and is expecting their home phone 408-555-6016 to ring simultaneously when their office phone is called. What configuration change needs to be made to allow this happen?
-
Select the Enable Move to Mobile check box.
-
Select the Enable Extend and Connect check box.
-
Select the Line Association check box.
-
Deselect the Enable Single Number Reach check box.
Answer: C
Question No: 38
Which three statements about SAF forwarding are true? (Choose three.)
-
It supports DNS and IP addresses.
-
The SAF Forwarder configuration can be updated without connecting to Cisco Unified Communications Manager.
-
It requires the SAF Forwarders to use the same configuration as the IOS switch.
-
It is supported on IPv4 only.
-
It is supported on IPv6 only.
-
It requires a unique IP address for each SAF Forwarder.
Answer: A,B,F
Question No: 39
You enabled Cisco Unified Mobile Connect for a user, but the user is unable to send calls to a mobile phone from the desk phone. What do you do to resolve the issue?
-
Restart the phone, and verify that the key is present.
-
Under User Management gt; User, make sure that the Mobility option is selected.
-
Make sure that the phone is subscribed to Extension Mobility.
-
Add the mobility key to the softkey template that the phone is currently using.
Answer: D
Question No: 40
Refer to Exhibit:
What was the cause for the call termination?
-
No route to called number
-
Outbound gateway was not found
-
Calling party abandoned the call
-
Called party cancelled the call
-
Call completed successfully
Answer: C
100% Ensurepass Free Download!
–Download Free Demo:300-080 Demo PDF
100% Ensurepass Free Guaranteed!
–300-080 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |
100-105 Dumps VCE PDF
200-105 Dumps VCE PDF
300-101 Dumps VCE PDF
300-115 Dumps VCE PDF
300-135 Dumps VCE PDF
300-320 Dumps VCE PDF
400-101 Dumps VCE PDF
640-911 Dumps VCE PDF
640-916 Dumps VCE PDF
70-410 Dumps VCE PDF
70-411 Dumps VCE PDF
70-412 Dumps VCE PDF
70-413 Dumps VCE PDF
70-414 Dumps VCE PDF
70-417 Dumps VCE PDF
70-461 Dumps VCE PDF
70-462 Dumps VCE PDF
70-463 Dumps VCE PDF
70-464 Dumps VCE PDF
70-465 Dumps VCE PDF
70-480 Dumps VCE PDF
70-483 Dumps VCE PDF
70-486 Dumps VCE PDF
70-487 Dumps VCE PDF
220-901 Dumps VCE PDF
220-902 Dumps VCE PDF
N10-006 Dumps VCE PDF
SY0-401 Dumps VCE PDF