[Free] 2018(Jan) EnsurePass Pass4sure Cisco 300-101 Dumps with VCE and PDF 291-300

By | January 29, 2018
0 Comment

Ensurepass.com : Ensure you pass the IT Exams
2018 Jan Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/300-101.html

Implementing Cisco IP Routing

Question No: 291 – (Topic 7)

Which type of BGP AS number is 64591?

  1. a private AS number

  2. a public AS number

  3. a private 4-byte AS number

  4. a public 4-byte AS number

Answer: A

Question No: 292 – (Topic 7)

An administrator needs to setup an NTP client to provide updates to local without synchronizing to server. What is the command?

  1. Serve

  2. Serve-only

  3. peer

Answer: A

Question No: 293 – (Topic 7)

An engineer executes the ip flow ingress command in interface configuration mode. What is the result of this action?

  1. It enables the collection of IP flow samples arriving to the interface.

  2. It enables the collection of IP flow samples leaving the interface.

  3. It enables IP flow while disabling IP CEF on the interface.

  4. It enables IP flow collection on the physical interface and its subinterfaces.

Answer: A

Question No: 294 – (Topic 7)

Which statement about the NPTv6 protocol is true?

  1. It is used to translate IPv4 prefixes to IPv6 prefixes.

  2. It is used to translate an IPv6 address prefix to another IPv6 prefix.

  3. It is used to translate IPv6 prefixes to IPv4 subnets with appropriate masks.

  4. It is used to translate IPv4 addresses to IPv6 link-local addresses.

Answer: B

Question No: 295 – (Topic 7)

A network administrator notices that the BGP state drops and logs are generated for missing BGP hello keepalives. What is the potential problem?

  1. Incorrect neighbor options

  2. Hello timer mismatch

  3. BGP path MTU enabled

  4. MTU mismatch

Answer: D

Question No: 296 – (Topic 7)

Company has migrated to IPv6 in their network. Which three IPv6 notations represent the same address? (Select three)

A. 2031::130F::9C0:876A:130B

B. 2031:0000:130F:0000:0000:09C0:876A:130B

C. 2031:0:130F:::9C0:876A:130B

D. 2031::130F:0::9C0:876A:130B

E. 2031:0:130F:0:0:09C0:876A:130B

F. 2031:0:130F::9C0:876A:130B

Answer: B,E,F Explanation:

With IP version 6, octets containing all zero#39;s can be simply represented as :, while consecutive zero fields can be represented as ::. ANSWER choices C and E are simply the shorthand version of the fully written IPv6 address shown in choice.

Question No: 297 – (Topic 7)

Which two phases of DMVPN allow to spoke sites to create dynamic tunnels to one another? (Choose Two)

  1. Phase 1

  2. Phase 2

  3. Phase 3

  4. Phase 4

  5. Phase 5

Answer: B,C

Question No: 298 – (Topic 7)

Which IPv6 address correctly compresses the IPv6 unicast address 2001:0:0:0:0DB8:0:0:417A?

A. 2001:0DB8:417A B. 2001::0DB8::417A C. 2001:::0DB8::417A

D. 2001:0DB8:0:0:417A E. 2001::DB8:0:0:417A F. 2001:::0DB8:0:0:417A

Answer: E Explanation:

The point of this question is the about the different form of Ipv6 address.

The IPv6 address is 128 bits long, written as eight 16-bit pieces, separated by colons. Each piece is represented by four hexadecimal digits. You can compact multiple contiguous fields of zero even further. This is the exception to the rule that at least one digit must be present in every field. You can replace multiple fields of zeros with double colons (::).

Note that :: can replace only one set of contiguous zero fields. Multiple ::s would make the

address ambiguous.

Question No: 299 – (Topic 7)

To configure 6to4 tunneling on a dual-stack edge router. Which three of the following are valid components in 6to4 Tunneling configuration? (Choose Three)

  1. IPv4 Tunnel IP address

  2. Tunnel mode (6to4)

  3. Tunnel Keepalives

  4. IPv4 Tunnel Destination

  5. IPv4 Tunnel Source

  6. 6to4 IPv6 address (within 2002::/16)

Answer: B,E,F

Question No: 300 – (Topic 7)

Which statement is a restriction for PPPoE configuration?

  1. Multiple PPPoE clients can use the same dialer interface.

  2. Multiple PPPoE clients can use the same dialer pool.

  3. A PPPoE session can be initiated only by the client.

  4. A PPPoE session can be initiated only by the access concentrator.

Answer: C

100% Ensurepass Free Download!
–Download Free Demo:300-101 Demo PDF
100% Ensurepass Free Guaranteed!
–300-101 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.