Ensurepass.com : Ensure you pass the IT Exams
2018 Jan Cisco Official New Released 300-115
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/300-115.html
Implementing Cisco IP Switched Networks
Question No: 181
Which option describes a limitation of LLDP?
-
LLDP cannot provide information about VTP.
-
LLDP does not support TLVs.
-
LLDP can discover only Windows servers.
-
LLDP can discover up to two devices per port.
Answer: A
Question No: 182
Refer to the exhibit.
How can the traffic that is mirrored out theGigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1 port?
-
Change the configuration for GigabitEthernet0/48 so that it is a member of VLAN 10.
-
Add an access list to GigabitEthernet0/48 to filter out traffic that is not in VLAN 10.
-
Apply the monitor session filter globally to allow only traffic from VLAN 10.
-
Change the monitor session source to VLAN 10 instead of the physical interface.
Answer: C
Question No: 183
What is the command forconfiguring root guard?
-
(config) spanning-tree guard root
-
(config-if) spanning-tree guard root
Answer: B
Question No: 184
A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?
-
The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
-
The port is removed from the EtherChannel group.
-
The port is put in the errdisabled state and can only be reenabled manually.
-
The operation is not allowed as an EtherChannel member cannot be a SPAN source port.
Answer: D
Question No: 185
An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to reach the web server. What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web server?
-
Enable Cisco Express Forwarding to allow for more effective traffic sharing over the EtherChannel bundle.
-
Adjust the EtherChannel load-balancing method based on destination IP addresses.
-
Disable spanning tree on all interfaces that are participating in the EtherChannel bundle.
-
Use link-state tracking to allow for improved load balancing of traffic upon link failure to the server.
-
Adjust the EtherChannel load-balancing method based on source IP addresses.
Answer: E
Question No: 186
In regards to Cisco Virtual Switching System, which technology is needed between two switches for them to act as one network element and share control information and data traffic ?
-
virtual port channel
-
EtherChannel
-
virtual switch link
-
trunk
Answer: C
Question No: 187
Which statement about the UDLD protocol is true?
-
UDLD is a Cisco-proprietary Layer 2 protocol that enables devices to monitor the physical status of links and detect unidirectional failures.
-
UDLD is a Cisco-proprietary Layer 2 protocol that enables devices to advertise their identity, capabilities, and neighbors on a local area network.
-
UDLD is a standardized Layer 2 protocol that enables devices to monitor the physical status of links and detect unidirectional failures.
-
UDLD is a standardized Layer 2 protocol that enables devices to advertise their identity, capabilities, and neighbors on a local area network.
Answer: A
Question No: 188
Refer to the exhibit.
All ports are members of VLAN 10. Considering the default cost of upstream bridges to the root bridge is equal, which option will be the new root port for VLAN 10?
-
interface f0/13
-
interface f0/14
-
interface f0/15
-
interface f0/21
Answer: D
Question No: 189
You administer a network that uses two routers, R1 and R2, configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows:
R1#configure terminal R1(config)#interface fa0/0
R1(config-if)#ip address 10.10.0.5 255.255.255.0
R1(config-if)#standby 1 priority 150
R1(config-if)#standbypreempt delay minimum 50 R1(config-if)#standby 1 track interface fa0/2 15
R1(config-if)#standby 1 ip 10.10.0.20
Which of the following describes the effect the quot;standby preempt delay minimum 50quot; command will have on router R1? (Select the best answer.)
-
The HSRP priority for router R1 will increase to 200.
-
Router R1 will become the standby router if the priority drops below 50.
-
The HSRP priority for router R1 will decrease to 50 points when Fa0/2 goes down.
-
Router R1 will wait 50 seconds beforeattempting to preempt the active router.
Answer: D
Question No: 190
Which command creates a login authentication method named quot;loginquot; that will primarily use RADIUS and fail over to the local user database?
-
(config)# aaa authentication login default radius local
-
(config)# aaa authentication login login radius local
-
(config)# aaa authentication login default local radius
-
(config)# aaa authentication login radius local
Answer: B
100% Ensurepass Free Download!
–Download Free Demo:300-115 Demo PDF
100% Ensurepass Free Guaranteed!
–300-115 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |
100-105 Dumps VCE PDF
200-105 Dumps VCE PDF
300-101 Dumps VCE PDF
300-115 Dumps VCE PDF
300-135 Dumps VCE PDF
300-320 Dumps VCE PDF
400-101 Dumps VCE PDF
640-911 Dumps VCE PDF
640-916 Dumps VCE PDF
70-410 Dumps VCE PDF
70-411 Dumps VCE PDF
70-412 Dumps VCE PDF
70-413 Dumps VCE PDF
70-414 Dumps VCE PDF
70-417 Dumps VCE PDF
70-461 Dumps VCE PDF
70-462 Dumps VCE PDF
70-463 Dumps VCE PDF
70-464 Dumps VCE PDF
70-465 Dumps VCE PDF
70-480 Dumps VCE PDF
70-483 Dumps VCE PDF
70-486 Dumps VCE PDF
70-487 Dumps VCE PDF
220-901 Dumps VCE PDF
220-902 Dumps VCE PDF
N10-006 Dumps VCE PDF
SY0-401 Dumps VCE PDF