Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 July Cisco Official New Released 300-360
100% Free Download! 100% Pass Guaranteed!
Designing Cisco Network Service Architectures
Question No: 41
Which two statements about both FCIP and iSCSI are correct? (Choose two.)
-
They support file-level storage for remote devices.
-
They require high throughput with low latency and low jitter.
-
Their purpose is to provide connectivity between host and storage
-
They support block-level storage for remote devices.
-
Their purpose is to provide connectivity between separate wide-area SANs.
Answer: D,E
Question No: 42
here are 3 steps to confirm whether a range of IP addresses can be summarized. Which of the following is used in each of these 3 steps?
-
The first number in the contiguous block of addresses
-
The last number in the contiguous block of addresses
-
The size of the contiguous block of addresses
-
The subnet mask of the original network address
Answer: C
Question No: 43
Which three options are basic design principles of the Cisco Nexus 7000 Series for data center virtualization? (Choose three.)
-
easy management
-
infrastructure scalability
-
cost minimization
-
upgrade of technology
-
transport flexibility
-
operational continuity
Answer: B,E,F
Question No: 44
Which IPv4 multicast technical component measure provides architectural security?
-
IGMP max groups
-
access lists
-
scoped addresses
-
state limit
Answer: C
Question No: 45
Which option is the Cisco recommendation for data oversubscription for access ports on the access-todistribution uplink?
-
4 to 1
-
20 to 1
-
16 to 1
-
10 to 1
Answer: B
Question No: 46
With respect to address summarization, which of the following statements concerning IPv4 and IPv6 is true?
-
The potential size of the IPv6 address blocks suggests that address summarization favors IPv6 over IPv4.
-
Role based addressing using wildcard masks to match multiple subnets is suitable for IPv4, but unsuitable for IPv6.
-
In order to summarize, the number of subnets in the IPv4 address block should be a power of 2 while the number of subnets in the IPv6 address block should be a power of 64.
-
WAN link addressing best supports summarization with a /31 subnet for IPv4 and a /126 for IPv6.
Answer: B Explanation:
http://www.ciscopress.com/articles/article.asp?p=1763921
quot;For IPv6 access lists, the wildcard masks are not usually used. All source and destination addresses are notated in the form of prefixes. Therefore, it is important that subnets that are to be grouped in an access list falling within a summarized address range.quot;
Question No: 47
Which one of these could you implement to sustain a large DDoS attack?
-
Stateful firewall
-
uRPF
-
Connections limits and timeouts
-
Access-lists
Answer: C
Question No: 48
When is a first-hop redundancy protocol needed in the distribution layer?
-
when the design implements Layer 2 between the access and distribution blocks
-
when multiple vendor devices need to be supported
-
when preempt tuning of the default gateway is needed
-
when a robust method of backing up the default gateway is needed
Answer: A
Question No: 49
Which option lists the EIGRP minimum timer settings for hello and dead timers in seconds?
-
4 and 6
-
2 and 4
-
2 and 6
-
Both 6
Answer: C
Question No: 50
How does ERS use the VLAN tag?
-
to provide service internetworking
-
to support transparency for Layer 2 frames
-
as a connection identifier to indicate destination
-
as a mapping to the DLCI in service internetworking
-
to provide a trunk by which all VLANs can navigate from one site to one or multiple sites
Answer: C
100% Dumps4cert Free Download!
–Download Free Demo:300-360 Demo PDF
100% Dumps4cert Pass Guaranteed!
–300-360 Dumps
Dumps4cert | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |