[Free] 2018(May) EnsurePass Testinsides Cisco 200-120 Dumps with VCE and PDF 211-220

Ensurepass.com : Ensure you pass the IT Exams
2018 May Cisco Official New Released 200-120
100% Free Download! 100% Pass Guaranteed!

CCNA Cisco Certified Network Associate CCNA

Question No: 211 – (Topic 5)

Which three statements about HSRP operation are true? (Choose three.)

1. The virtual IP address and virtual MA K44C address are active on the HSRP Master router.

2. The HSRP default timers are a 3 second hello interval and a 10 second dead interval.

3. HSRP supports only clear-text authentication.

4. The HSRP virtual IP address must be on a different subnet than the routers#39; interfaces on the same LAN.

5. The HSRP virtual IP address must be the same as one of the router#39;s interface addresses on the LAN.

6. HSRP supports up to 255 groups per interface, enabling an administrative form of load balancing.

Answer: A,B,F

Question No: 212 – (Topic 5)

Which statement is correct regarding the operation of DHCP?

1. A DHCP client uses a ping to detect address conflicts.

2. A DHCP server uses a gratuitous ARP to detect DHCP clients.

3. A DHCP client uses a gratuitous ARP to detect a DHCP server.

4. If an address conflict is detected, the address is removed from the pool and an administrator must resolve the conflict.

5. If an address conflict is detected, the address is removed from the pool for an amount of time configurable by the administrator.

6. If an address conflict is detected, the address is removed from the pool and will not be reused until the server is rebooted.

Answer: D

Question No: 213 – (Topic 5)

Refer to the exhibit.

The Bigtime router is unable to authenticate to the Littletime router. What is the cause of the problem?

1. The usernames are incorrectly configured on the two routers.

2. The passwords do not match on the two routers.

3. CHAP authentication cannot be used on a serial interface.

4. The routers cannot be connected from interface S0/0 to interface S0/0.

5. With CHAP authentication, one router must authenticate to another router. The routers cannot be configured to authenticate to each other.

Answer: B

Question No: 214 – (Topic 5)

Which three features are added in SNMPv3 over SNMPv2?

1. Message Integrity

2. Compression

3. Authentication

4. Encryption

5. Error Detection

Answer: A,C,D

Question No: 215 – (Topic 5)

What command instructs the device to timestamp Syslog debug messages in milliseconds?

1. service timestamps log datetime localtime

2. service timestamps debug datetime msec

3. service timestamps debug datetime localtime

4. service timestamps log datetime msec

Answer: B

Question No: 216 – (Topic 5)

Which three statements about the features of SNMPv2 and SNMPv3 are true? (Choose three.)

1. SNMPv3 enhanced SNMPv2 security features.

2. SNMPv3 added the Inform protocol message to SNMP.

3. SNMPv2 added the Inform protocol message to SNMP.

4. SNMPv3 added the GetBulk protocol messages to SNMP.

5. SNMPv2 added the GetBulk protocol message to SNMP.

6. SNMPv2 added the GetNext protocol message to SNMP.

Answer: A,C,E

Question No: 217 – (Topic 5)

What is the default Syslog facility level?

1. local4

2. local5

3. local6

4. local7

Answer: D

Question No: 218 – (Topic 5)

Syslog was configured with a level 3 trap. Which 3 types of logs would be generated (choose four)

1. Emergencies

2. Alerts

3. Critical

4. Errors

5. Warnings

Answer: A,B,C,D

Question No: 219 – (Topic 5)

Refer to the exhibit.

What statement is true of the configuration for this network?

1. The configuration that is shown provides inadequate outside address space for translation of the number of inside addresses that are supported.

2. Because of the addressing on interface FastEthernet0/1, the Serial0/0 interface address will not support the NAT configuration as shown.

3. The number 1 referred to in the ip nat inside source command references access-list number 1.

4. ExternalRouter must be configured with static routes to networks 172.16.1.0/24 and 172.16.2.0/24.

Answer: C

Question No: 220 – (Topic 5)

When a DHCP server is configured, which two IP addresses should never be assignable to hosts? (Choose two.)

1. network or subnetwork IP address

2. broadcast address on the network

3. IP address leased to the LAN

4. IP address used by the interfaces

5. manually assigned address to the clients

6. designated IP address to the DHCP server

Answer: A,B

100% Ensurepass Free Download!
–Download Free Demo:200-120 Demo PDF
100% Ensurepass Free Guaranteed!
–Download 2018 EnsurePass 200-120 Full Exam PDF and VCE

	EnsurePass	ExamCollection	Testking
Lowest Price Guarantee	Yes	No	No
Up-to-Dated	Yes	No	No
Real Questions	Yes	No	No
Explanation	Yes	No	No
PDF VCE	Yes	No	No
Free VCE Simulator	Yes	No	No
Instant Download	Yes	No	No