[Free] 2019(Nov) EnsurePass Cisco 300-360 Dumps with VCE and PDF 11-20

By | November 3, 2019

Get Full Version of the Exam

Question No.11

You must redesign an existing wireless network that spans multiple floors to support location- based services. Where do you install the access points?

  1. in the elevators

  2. in the perimeter of each floor

  3. in the stairwells of each floor

  4. in the center of each floor

Correct Answer: D

Question No.12

A customer has dual-band devices that they want to use 40 MHz channels. If the customer is using Cisco 3600 Series access points with a 5508 controller. Which setting assists with this change?

  1. Enable band select globally.

  2. Enable aggressive load balancing.

  3. Disable lower data rates on 802 .11G GHz radios.

  4. Disable overlapping 802.11G channels.

Correct Answer: A

Question No.13

Which option will allow the maximum 2.4 GHz channel usage for a survey and voice deployment in the ETSI domain?


1, 6, 11


1, 5, 9, 13


1, 6, 9, 14


1, 6, 11, 14

Correct Answer: A

Question No.14

An engineer must design a wireless voice network and is auditing the existing configuration. Which two actions must be taken? (Choose two.)

  1. Enable Platinum QoS profile on the SSID

  2. Disable Coverage Hole Detection.

  3. Ensure the switch ports trust DSCP QoS markings

  4. Disable WMM on the QoS tab

  5. Ensure that Client Load Balancing is enabled.

Correct Answer: AC


Understanding Wireless QoS – Part 1

Question No.15

A hospital environment was designed to guarantee RF coverage at or better than -67 dBm in the 5 GHz spectrum. The customer mandates that RRM be used for DCA and TPC in both bands.

After deployment, why do many of the legacy 802.11b/g devices have difficulty maintaining connectivity?

  1. Excessive co-channel interference in the 2.4 GHz band exists.

  2. Excessive overlapping channels in the 2.4 GHz band exists.

  3. TPC drastically reduces Tx power in the 2.4 GHz band.

  4. TCP drastically increases Tx power in the 2.4 GHz band.

Correct Answer: D

Question No.16

A wireless phone user is having roaming difficulties and is experiencing gaps in the conversation while roaming. WLC WLAN is configured as IEEE 802.1X and WPA2 and Aironet information element. What should be configured to fix the problem?

  1. IEEE 802.1X with Cisco Centralized Key Management

  2. IEEE 802.1X EAP-FAST

  3. DHCP required and DHCP proxy on WLC

  4. WPA1 and PSK

    Correct Answer: A


    https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-1/Enterprise-Mobility-8-1-Design- Guide/Enterprise_Mobility_8-1_Deployment_Guide.pdf

    Question No.17

    A network engineer is configuring QoS with a DSCP value of 46. To which queue must the CoS be mapped for priority queuing of the voice frames?









  5. 3

Correct Answer: C

Question No.18

While performing a Layer 1 passive wireless site survey of a location an engineer detects several instances of low power frequency hopping interference, but cannot physically locate the interfering device or devices. Why is the engineer unable to locate the offending device or devices?

  1. The sources are nearby narrow-beam radar and are sweeping through the facility.

  2. The sources are PAN and are mobile.

  3. The sources are above the ceiling file and transmit intermittently.

  4. The sources are actually high-powered devices and transmit from off the site.

Correct Answer: B

Question No.19

An engineer is preparing for an active site survey of a hospital and is informed that he or she should not enter any active surgery suites. Which option describes how the engineer should address this restriction?

  1. Conduct a passive wireless survey in the restricted areas.

  2. Use the predictive AP placement tool on the wireless controller

  3. Skip the area and estimate where to place the access points.

  4. Arrange to perform survey activities after hours.

Correct Answer: A Explanation: Passive Survey

Passive surveys are surveys that are performed with a listen-only mode. The survey client never associates to the access point (AP). Such surveys can be helpful when you look for rogue devices or you want a good gauge of downlink RF coverage from the infrastructure devices.

These can be accomplished with a passive survey.

Question No.20

An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?









Correct Answer: D


You can order Cisco 5500 Series Controllers with support for 12, 25, 50, 100, 250 or 500 APs as the controller#39;s base capacity. You can add additional AP capacity through capacity adder licenses available at 25, 50, 100 and 250 AP capacities. You can add the capacity adder licenses to any base license in any combination to arrive at the maximum capacity of 500 APs.




Get Full Version of the Exam
300-360 Dumps
300-360 VCE and PDF

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.