[Free] 2019(Nov) EnsurePass IASSC ICBB Dumps with VCE and PDF 131-140

By | November 4, 2019

Get Full Version of the Exam

Question No.131

A valid Multiple Linear Regression (MLR) is characterized by all of these except?

  1. It is an assumption that the X#39;s (inputs) are not correlated to each other

  2. The X#39;s (inputs) are assumed to be independent of each other

  3. The Residuals from MLR analysis have to be Normally Distributed

  4. MLR is conducted based on a deliberate form of experimentation

  5. It is not possible to evaluate interactions in a MLR analysis

Correct Answer: D

Question No.132

A valuable tool to use during the Measure Phase to show material and information flow throughout an entire process is the .

  1. Value Stream Map

  2. FMEA

  3. Pareto Chart

  4. Standard Operating Procedure

Correct Answer: A

Question No.133

A Belt has determined that the inventory of repair parts at a rework station can be reduced by 45%. According to Cost of Poor Quality (COPQ) definitions inventory reduction would be considered .

  1. Soft Savings

  2. COPQ efficiency

  3. Median Savings

  4. Hard Savings

Correct Answer: D

Question No.134

What conclusion is most correct about the Experimental Design shown here with the response in the far right column?


  1. No factor has enough statistical confidence greater than 95% to have an impact on the response rate

  2. Constant, Adv and Bev are the only factors statistically affecting the response rate with 95% confidence or more

  3. If the Adv is increased from the low level to the high level, the response rate increases

  4. The response level is statistically concluded to only need the Adv and Bev factors set at the low level to get the largest response rate

  5. This design does not have enough experimental runs to conclude anything as evidenced by the lack of P-values in the MINITABTM output

Correct Answer: D

Question No.135

Use this data to calculate the Z Score. Average of:92, Standard Deviation: 2, Upper Spec Limit: 101









Correct Answer: D

Question No.136

Much of the Six Sigma methodology is used to identify and remove causes for .

  1. Process Variation

  2. Material Costs

  3. Excess Inventory

  4. Lost Sales

Correct Answer: A

Question No.137

On a a Belt screens variables, or various inputs, to analyze their relative impact on the output of concern.

  1. X-Y Matrix

  2. Weighted Scale

  3. Multi-Vari Chart

  4. Poisson Chart

Correct Answer: C

Question No.138

It would be more likely than not for a Belt conducting a Regression Analysis to find that the


  1. r2 value is smaller than the absolute value of r

  2. Correlation Coefficient equals r2

  3. Coefficient of Determination is less than r2

  4. Correlation Coefficient equals r divided by 2

Correct Answer: A

Question No.139

For the data set shown here which of these statements is/are true?


  1. Hypothesis Testing of Means or Medians cannot be done since there are an unequal number of observations for the 3 samples

  2. A Paired T-test would be applicable for comparing Grade B and Grade A since they follow each other in the data set

  3. Grade A has the lowest sample Mean of the 3 samples

  4. Grade A has a higher sample Mean than Grade B

Correct Answer: C

Question No.140

One of the primary deliverables from performing a SIPOC is to begin to understand which outputs have the greatest affect on the customer most valued inputs.

  1. True

  2. False

Correct Answer: B

Get Full Version of the Exam
ICBB Dumps

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.