[Free] Download New Updated (December) Cisco 350-080 Exam Questions 71-80

By | December 12, 2015

Ensurepass

QUESTION 71

Which two statements about VACLs on Cisco Nexus 7000 Series Switches are true? (Choose two.)

 

A.

A single VACL can be shared across two or more VDCs.

B.

Use of VACLs requires no special license to be installed.

C.

VACLs make use of IP or MAC ACLs.

D.

Only options drop and forward are permitted.

 

Correct Answer: BC

 

 

 

 

 

QUESTION 72

Which two statements about a “Virtual PortChannel graceful consistent check” are true?

 

A.

Graceful consistency check is enabled by default.

B.

When graceful consistency check is enabled, only the links on the secondary peer device are suspended.

C.

Graceful consistency check is disabled by default, so to enable this feature, use graceful consistency-check command under VPC domain configuration mode.

D.

When graceful consistency check is enabled, only the inconsistent VLANs on the secondary peer device are suspended.

 

Correct Answer: AB

 

 

QUESTION 73

Which attribute is used to pass the user role back to the Nexus when remote AAA is enabled?

 

A.

Cisco AV-pair

B.

TACACS+ or RADIUS ack frame role attribute

C.

DH-CHAP challenge attribute

D.

privilege level attribute

 

Correct Answer: A

 

 

QUESTION 74

Each port that is configured to use LACP has an LACP port priority. Which statements are true about LACP port priority? (Choose three.)

 

A.

Port priority value can be configured between 1 and 65535.

B.

A higher port priority value means a higher priority of LACP.

C.

Port priority can be configured so that specific links can be chosen as active links rather than the hot standby links within the port channel.

D.

LACP uses the port priority with the port number to form the port identifier.

E.

LACP Port priority default value should always be changed

 

Correct Answer: ACD

 

 

QUESTION 75

What will this command sequence achieve?

 

Nexus7000# config t

 

Nexus700(config)# interface ethernet 2/11

 

Nexus700(config-if)# switchport mode private-vlan host

 

Nexus700(config-if)# switchport private-vlan host-association 14 50

 

Nexus700(config-if)# exit

 

Nexus700(config)#

 

A.

associate interface E2/11 to community VLANs 14 and 50

B.

associate interface E2/11 to secondary VLANs 14 and 50

C.

associate interface E2/11 to primary VLAN 50 and secondary VLAN 14

D.

associate interface E2/11 to primary VLAN 14 and secondary VLAN 50

 

Correct Answer: D

 

 

QUESTION 76

Which command will allow you to display the configured QoS group and the ingress buffer allocated to each QoS group?

 

< td style="border-top-style: none; border-left-style: none; background: white; border-bottom-style: none; padding-bottom: 0cm; padding-top: 0cm; border-right-style: none; padding-left: 0cm; padding-right: 0cm" valign="top" width="26">

D.

A.

show interface priority-flow-control

B.

show interface queuing

C.

show queuing interface

show policy-map system type queuing

E.

show policy-map interface ethernet <x/y> type queuing

 

Correct Answer: C

 

 

QUESTION 77

Refer to the exhibit. During troubleshooting of Virtual PortChannel (vPC), it is observed that Virtual PortChannel 2 is in a down state. What’s the cause of this issue?

 

clip_image002

A.

Virtual PortChannel is down because LACP is not enabled on the remote switch.

B.

Virtual PortChannel is down because of a VLAN mismatch.

C.

Virtual PortChannel is down because of an MTU mismatch.

D.

Virtual PortChannel is down because of VLAN and MTU mismatch.

 

Correct Answer: C

 

 

QUESTION 78

With Cisco NX-OS on a Cisco Nexus platform, which command shows memory usage, total processes, and CPU state?

 

A.

show memory detailed

B.

show process cpu sorted

C.

show system resources

D.

show hardware capacity

 

Correct Answer: C

 

 

QUESTION 79

What is the difference between the Ethanalyzer and the SPAN feature in Cisco NX-OS?

 

A.

The Ethanalyzer captures control-plane traffic, while SPAN captures all traffic.

B.

The Ethanalyzer captures all traffic including control-plane traffic, while SPAN captures only the control-plane traffic.

C.

The Ethanalyzer captures only data traffic, while SPAN captures all traffic.

D.

The Ethanalyzer captures only control traffic, while SPAN captures data traffic.

 

Correct Answer: A

 

 

QUESTION 80

Virtual PortChannels (vPCs) allow links that are physically connected to two different Cisco switches to appear to a third downstream device as coming from a single device and as part of a single port channel. Which of the following are components of a Virtual PortChannel system? (Choose four)

 

A.

Two peer devices: the vPC peers of which one is primary and one is secondary and are part of a vPC domain.

B.

A Layer 3 Gigabit Ethernet link called peer-keepalive link to resolve dual-active scenarios

C.

A redundant 10 Gigabit Ethernet PortChannel called a peer link to carry traffic from one system to the other when needed

D.

vPC member ports forming the PortChannel

E.

A dot1q trunk between the vPC peers

F.

A management port that can be used as peer-keepalive link to resolve dual-active scenarios.

 

Correct Answer: ABCD

 

Free VCE & PDF File for Cisco 350-080 Exam Questions

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …