traceroute command

By | June 8, 2020

The traceroute command on a Cisco device can be used to identify the path used by a packet to reach its target. It identifies all the routers in the path from the source host to destination host and it can be useful when troubleshooting network problems. Using this command you can figure out which router in the path to an unreachable target should be examined more closely as the probable cause of the network’s failure.

Consider the following example network:

traceroute command example network

In the picture above you can see that we have a network of four routers. The network is working correctly. Consider what happens when we issue the traceroute command on R1 to the IP address of the router’s R4 Gi0/0 interface (

Type escape sequence to abort.
Tracing the route to
1 0 msec 0 msec 0 msec
2 0 msec 0 msec 0 msec
3 0 msec 0 msec 0 msec

You can see that the traceroute command has listed the IP addresses of all of the routers in the path to the destination. Now let’s assume that the router R3 goes down. Consider the command output now:

Type escape sequence to abort.
Tracing the route to
1 0 msec 0 msec 0 msec
2 !H * !H
3 * *

Notice how there is no response from R3 ( Using this information, we can assume that there is a problem with R3 and investigate the matter. The !H in the output indicates that the host is unreachable. Other character that can appear in the traceroute command output are:

  • number of miliseconds – the round-trip time in milliseconds.
  • * – the probe has timed out.
  • A – administratively prohibited (for example, with an access-list).
  • Q – source quench (the destination is too busy).
  • I – user interrupted test.
  • U – port is unreachable.
  • N – the network is unreachable.
  • P – the protocol is unreachable.
  • T – timeout.
  • ? – unknown packet type.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo