[Free] 2018(July) Dumps4cert Cisco 352-001 Dumps with VCE and PDF Download 191-200

By | July 26, 2018

Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 July Cisco Official New Released 352-001
100% Free Download! 100% Pass Guaranteed!

Designing Cisco Network Service Architectures

Question No: 191

Which action can be taken on a multiaccess segment with OSPF speakers to reduce the performance impact during widespread convergence events?

  1. Separate the network into multiple areas for each new multiaccess segment.

  2. Enable LSA throttling in the core to slow link state advertisement updates during times of network instability.

  3. Ensure that the elected DR or BDR router can support high-volume convergence events.

  4. Verify that fewer than 50 OSPF speakers are on the segment.

Answer: B



quot;It is worth noting that three most important timers to tune network for sub-second convergence are the failure detection delay, initial LSA generation delay and initial SPF delay. All other timers, such as hold and maximum time serve the purpose of stabilizing network, and affect convergence in “worst-case” unstable network scenarios.quot;

More info on LSA throttling: https://www.cisco.com/c/en/us/td/docs/ios/12_0s/feature/guide/fsolsath.html

quot;Benefits of OSPF LSA Throttling Prior to the OSPF LSA Throttling feature, LSA generation was rate-limited for 5 seconds. That meant that changes in an LSA could not be propagated in milliseconds, so the OSPF network could not achieve millisecond convergence. The OSPF LSA Throttling feature is enabled by default and allows faster OSPF convergence (in milliseconds). This feature can be customized. One command controls the generation (sending) of LSAs and another command controls the receiving interval. This feature also provides a dynamic mechanism to slow down the frequency of LSA updates in OSPF during times of network instability.quot;

Question No: 192

What is the correct state between two BGP peers that are neighbors?

  1. active

  2. operational

  3. established

  4. up

Answer: C

Question No: 193 DRAG DROP

Drag the IS-IS fast convergence components on the left to the order in which they occur on

the right.

Ensurepass 2018 PDF and VCE


Ensurepass 2018 PDF and VCE

Explanation: First – Failure detection time Second – Event propagation time

Third – SPF run time

Fourth – RIB FIB update time

Question No: 194

Which option is a benefit of site-to-site VPNs?

  1. Less configuration required than a WAN circuit

  2. More secure than a dedicated WAN circuit

  3. Less expensive than a dedicated WAN circuit

  4. More reliable than a dedicated WAN circuit

Answer: C

Question No: 195

Distinct, physical redundancy within a network layer is a key characteristic that contributes to the high availability of the hierarchical network design. Which of the following is not an examples of this model?

  1. SAN extension with dual fabrics such as a yellow VSAN and a blue VSAN utilized via multipath software

  2. Redundant power supplies and hot-swappable fan trays in Aggregate switches

  3. A single SAN fabric with redundant uplinks and switches

  4. Servers using network adapter teaming software connected to dual-attached access switches

Answer: A

Question No: 196

When designing data centers for multitenancy, which two benefits are provided by the implementation of VSAN and zoning? (choose two)

  1. VSAN provides a means of restricting visibility and connectivity among devices connected to a zone

  2. VSANs have their own set of services and address space, which prevents an issue in one VSAN from

    affecting others

  3. Zones provide the ability to create many logical SAN fabrics on a single Cisco MDS 9100 family switch

  4. VSANs and zones use separate fabrics

  5. Zones allow an administrator to control which initiators can see which targets

Answer: B,E

Question No: 197

OTV relies on which underlying protocol?

  1. EIGRP

  2. IS-IS

  3. OSPF

  4. BGP

Answer: B

Question No: 198

Which QoS mechanism uses PHBs?

  1. DiffServ

  2. IntServ

  3. CoS

  4. ToS

Answer: A

Question No: 199

A designer should have which three technologies in the network before configuring MPLS Layer 3 VPNs? (Choose three.)

  1. MPLS

  2. LDP

  3. Cisco Express Forwarding

  4. VSS

  5. vPC

  6. VRRP

Answer: A,B,C

Question No: 200

Which two design concerns must be addressed when designing a multicast implementation? (Choose two.)

  1. only the low-order 23 bits of the MAC address are used to map IP addresses

  2. only the low-order 24 bits of the MAC address are used to map IP addresses

  3. only the high-order 23 bits of the MAC address are used to map IP addresses

  4. only the low-order 23 bits of the IP address are used to map MAC addresses

  5. the 0x01004f MAC address prefix is used for mapping IP addresses to MAC addresses

  6. the 0x01005e MAC address prefix is used for mapping IP addresses to MAC addresses

Answer: A,F

100% Dumps4cert Free Download!
Download Free Demo:352-001 Demo PDF
100% Dumps4cert Pass Guaranteed!
352-001 Dumps

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.